Computer Networking MCQs

it includes computer networking mcqs ,computer mcq,basic computer mcqs for nts,operating system mcq with answers,mcqs of computer ms office,computer telephone wireless operator mcqs,computer mcq questions,basic it knowledge mcqs,computer network mcqs,ppsc computer science lecturer past papers,basic computer science mcqs

Q: Two computers that communicate with each other use a simple parity check to detect errors for ASCII transmissions. Which of the following events will always lead to an undeleted error??

A. one bit or any odd number of bits inverted in a block of data during transmission
B. two bits or any even number of bits inverted in a block during transmission
C. one bit or any odd number of bits inverted in a byte during transmission
D. two bits or any even number of bits inverted in a byte during transmission


View Answer

Q: IEEE project 802 divides the data link layer into an upper _____ sublayer and a lower _____ sublayer.?

A. HDLC, PDU
B. PDU, HDLC
C. MAC, LLC
D. LLC, MAC


View Answer

Q: A smart modem can dial, hang up and answer incoming calls automatically. Can you tell who provides the appropriate instruction to the modem for this purpose??

A. Communications software
B. Error detecting protocols
C. Link access procedure (LAP)
D. Telecommunications


View Answer

Q: With an IP address of 201.142.23.12, what is your default subnet mask??

A. 0.0.0.0
B. 255.0.0.0
C. 255.255.0.0
D. 255.255.255.0


View Answer

Q: The frequency range : 300 kHz to 3 MHz is used for?

A. AM radio transmission
B. FM radio transmission
C. TV transmission
D. microwave communications, satellite and radar


View Answer

Q: Propagation delay depends on?

A. Packet length
B. Transmission rate
C. Distance between the routers
D. None of the mentioned


View Answer

Q: Transmission delay does not depend on?

A. Packet length
B. Distance between the routers
C. Transmission rate
D. None of the mentioned


View Answer

Q: In a network If P is the only packet being transmitted and there was no earlier transmission which of the following delays could be zero?

A. Propogation delay
B. Queuing delay
C. Transmission delay
D. Processing delay


View Answer

Q: The total nodal delay is given by?

A. dnodal = dproc – dqueue + dtrans + dprop
B. dnodal = dproc + dtrans – dqueue
C. dnodal = dproc + dqueue + dtrans + dprop
D. dnodal = dproc + dqueue – dtrans – dprop


View Answer

Q: If end to end delay is given by dend-end = N(dproc + dtrans + dprop) is a non congested network. The number of routers between source and destination is?

A. N/2
B. N
C. N-1
D. 2N


View Answer